After Usage - MESTO PRIMER 3237P Instrucciones De Uso

GB IRL
Spraying
Observe the instructions in the section entitled "Safety".
Operate the device only while it is vertical or suspended upright and nearly vertical.
Avoid allowing drops of spray to drift onto areas that are not being treated.
Observe the instructions of the spray product manufacturer!
1. Hang the device over your shoulder. (Fig. 11)
To prevent dripping, hold the spray wand up when first spraying and activate the shut-
off valve until no more liquid mixed with air is emerging from the nozzle.
2. Activate the shut-off valve [4] (Fig. 12)
Spraying may now begin.
3. Make certain the optimum spraying pressure is set (→ Table 2) on the piston pressure
gauge [10] (Fig. 10).
Spraying pressure
1.5 bar
2.0 bar
3.0 bar
Table 2. Linear dependence: spraying rate and spraying pressure
4. If the spraying pressure decreases more than 0.5 bar from the optimum level, pump
some more.
If liquid mixed with air emerges from the nozzle, the tank is empty.

After Usage

Observe the instructions in the section entitled "Safety".
1. Pull up the red button on the piston pressure gauge [10] until all excess pressure is
released from the tank (Fig. 4)
2. Lock the piston rod with handle [11]. (Fig. 5)
3. Unscrew the pump [2] from the tank. (Fig. 6)
4. Empty and rinse the device with clear water.
Collect and dispose of the residual liquid according to all applicable laws,
requirements and regulations. Observe the instructions of the spray product
manufacturer!
5. Wipe off the device with a moist cloth.
6. For drying and storing the device, keep the tank [1] and pump [2] separate in a dry place
protected from sunlight and freezing temperatures (Fig. 13).
Clean the protective equipment and yourself every time after usage.
AUS USA
Spraying rate with flat jet nozzle (original equipment)
15
NZ CDN
0.56 l/min
0.64 l/min
0.78 l/min
IND