Connecting The Controller / Manual Control Switch; Alpha Colonne With Internal Controller; Alpha Colonne With External Controller: Function Up - Down Or Up - Down With Speed Control; Alpha Colonne With External Controller: Function Memory, Synchronous - Phoenic Mecano Alpha Colonne Instrucciones De Montaje

7.5 Connecting the controller / manual control switch

Details for configuring, operating the controller via the manual control switch as well as fault co-
des can be obtained in the controller operating instructions.

7.5.1 Alpha Colonne with internal controller

The controller is installed in the lifting column.
Connecting the hand switch
•
Two-button manual control switch (Up - Down) for traversing the lifting column. The manual
control switch is connected directly to the lifting column.
7.5.2 Alpha Colonne with external controller: function Up - Down or
Up - Down with speed control
The lifting column is connected to the external controller.
Maximum two lifting columns can be traversed.
The following external controllers can be exempted:
•
MBL - Transformer controller 120VA (for Up - Down)
•
RK MultiControl mono with speed control
Connecting the hand switch
The manual control switch is connected directly to the lif-
ting column.
•
Two-button manual control switch (Up - Down) for traversing the lifting column.
•
Six-button manual control switch (6 pin manual control switch socket) for traversing the lifting
column individually or parallel.
7.5.3 Alpha Colonne with external controller: Function memory, synchro-
nous
The lifting column is connected to the external controller.
It can traverse up to four lifting columns (depending on the loading data and requirements).
The following external controllers can be exempted:
•
RK MultiControl duo for up to 2 lifting columns synchronously with memory position
•
RK MultiControl quadro for up to 4 lifting columns synchronously
Connecting the hand switch
•
Two-button manual control switch (Up - Down) for traversing the lifting column.
•
Six-button manual control switch with display (6-pin manual control switch connector) for tra-
versing lifting columns. Saving of user-specific positions and carrying out settings.
•
Eight-button radio controlled switch with display and basis station (serial connection) for tra-
versing lifting columns. Saving of user-specific positions and carrying out settings.
7. Life phases
61