Safety Instructions; Mounting Instructions - DURAVIT SensoWash Starck f 251009 20 Serie Instrucciones De Montaje

Information about the mounting instructions
These mounting instructions come as part of the Duravit product
and should be read carefully prior to installation.
Target readership and qualifications
The product should only be installed by qualified plumbers.
The electrical installation should be carried out by qualified
electricians.
Explanation of the signal words and symbols
Indicates a hazardous situation which, if
DANGER
not avoided, will result in death or serious
injury.
Is used to address practices not related to
NOTE
physical injury.
Link to the electrical installation section
Link to the mounting instructions in this section
Link to the water installation section
Link to other instructions
Inspection (e.g. for scratches)
Check for leaks
> Action required
6
57370_MAL_SeWa_Starck f_Installation kit #100731/19.12.1

Safety instructions

Risk of fatal electric shock!
> Disconnect the power supply while working on the electrical
components.
> Prevent the power supply from being switched on accidentally
by third parties.
> Connect the device only to the designated electrical cable.
> Never touch the power supply line with wet hands.
> Check the rating label for the rated power and choose the
cable cross section accordingly.
Product and/or property damage
> Only use the parts in the installation kit to avoid malfunctions.
> Do not use attachments not recommended by Duravit.
Standards and regulations
The breach of local and country-specific regulations and standards
can cause damage to the product and/or property damage.
> Observe the local installation regulations and any country-
specific standards at all times.

Mounting instructions

These instructions describe the installation of the SensoWash
Starck f installation kit in combination with a wall-mounted toilet
and front-wall element with ductwork. The complete installation
of the Starck f wall-mounted toilet and shower toilet unit is
described in the respective enclosed instructions.
8
Checking the pre-installation
> Check whether the push plate of the front-wall element
and wall-mounted toilet are disassembled. Disassemble
other elements if necessary.
> Check whether the electrical installation has already been
carried out.