Scope Of Delivery; Instructions For Use; Preparing The Product For Use - Ottobock 5R2 Instrucciones De Uso

Signs of changes in or loss of functionality during use
Among other factors, changes in functionality can be indicated by an
altered gait pattern, a change in the positioning of the prosthetic com­
ponents relative to each other and by the development of noises.

4 Scope of delivery

5R2 Lamination disc
Quantity Designation
1

Instructions for use

1 Lamination disc
1 Lamination dummy
The following parts are only for: connection to 4R22, 4R23,
4R54, 4R55, 4R73=A, 4R73=D, 4R74, 4R95 socket adapter
4 Countersunk screw
The following parts are only for: connection to 4R37, 4R51,
4R77 socket adapter
4 Countersunk screw
The following parts are only for: connection to 6A30=20N
shuttle lock
6 Oval head self-tapping screw

5 Preparing the product for use

CAUTION
Incorrect alignment or assembly
Risk of injury due to damaged prosthetic components
► Observe the alignment and assembly instructions.
INFORMATION
The layup described in this document was approved for the maxim­
um product user body weight. The prosthetist assumes full respons­
ibility for any change to the layup.
10
5.1 Preparing for socket fabrication
>
1) Pull a soaked PVA bag over the model.
2) Apply one layer of Dacron felt to the model and thin out the fibres
Reference num­
ber
3) Pull two layers of Perlon stockinette over the model.
–
4) Place three layers of carbon fibre cloth (e.g. 15 c m x 1 5 cm), off­
–
4X86
5) Pull two layers of Perlon stockinette over the model.
6) Pull a soaked PVA bag over the model.
7) Perform the lamination process with Orthocryl.
501S41=M6x12
8) Once the lamination resin has cured, remove the PVA bag.
9) Foam the distal end of the model with Pedilen rigid foam.
10) Trim the rigid foam, sand it flat in the desired position and taper it
501S41=M6x16
11) Apply sealing resin to the rigid foam.
12) Fill the holes on the underside of the lamination disc with
501S74=3.5x9.5
13) Apply silicone grease to the contact surface of the lamination
5.2 Fabricating the prosthetic socket
>
1) Prepare for fabrication of the prosthetic socket (see page 10).
2) Stitch 2 layers of Nylglass stockinette and pull them over the mod­
3) Pull 1 layer of fibreglass mat over the model.
Required tools and materials:
99B81 PVA bag, 616G6 Dacron® felt, 623T3 Perlon stockinette,
616G12 carbon fibre cloth, 300 617H32* Pedilen rigid foam,
636K8* plastaband, 633F23=1 silicone grease, 617H21 Orthocryl
sealing resin, 617H119 80:20 PRO Orthocryl lamination resin
along the edge.
set on the distal end of the model.
below the flat surface (see fig. 2).
plastaband.
dummy and put on the lamination dummy (see fig. 3).
Required tools and materials:
99B81 PVA bag, 623T9 Nylglass stockinette, 616G4 fibreglass
mat, 616G12 carbon fibre cloth, 616G14* woven carbon fibre­
glass stockinette, 617H119 80:20 PRO Orthocryl lamination resin
el.