Makita GS5000 Manual De Instrucciones página 6

For tool with the lock on and lock-off
switch
To prevent the switch trigger from accidentally pulled, a
lock lever is provided.
To start the tool, push in the lock lever (in the A direc-
tion) and then pull the switch trigger (in the B direction).
Release the switch trigger to stop.
For continuous operation, push in the lock lever (in the
A direction), pull the switch trigger (in the B direction)
and then pull the lock lever (in the C direction).
To stop the tool from the locked position, pull the switch
trigger fully (in the B direction), then release it.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
► 1. Hex wrench 2. Hex bolt 3. Hex lock nut 4. Tighten
5. Loosen
CAUTION:
• When the wheel cover is positioned for more
safety, tighten the two hex bolts by the strength
more than 10 N•m to secure the wheel cover
properly.
Installing or removing grinding
wheel
Optional accessory
CAUTION:
• Before installing grinding wheel, always check
that a blotter part does not have any abnormali-
ties such as chips or cracks.
• Overtightening the wheel can cause breakage.
Failure to tighten sufficiently will cause flutter.
Tighten the outer flange properly.
• Always use the grinding wheel with the blotter
that has larger diameter than the lock nut or the
outer flange and the inner flange.
For tool with support cover only
(country specific)
► 1. Wing bolt 2. Support cover
Before installing or removing the grinding wheel, open
the support cover. Loosen the wing bolts on both sides
of the support cover and then open it.
After securing the wheel grinding, close the support
cover and then secure the wing bolts properly.
1
Tool with the outer flange (convex type)
5
2
4
3
► 1. Hex nut 2. Outer flange (convex type) 3. Grinding
Tool with the outer flange (flat type)
► 1. Hex nut 2. Outer flange (flat type) 3. Grinding
6 ENGLISH
1
2
1
2
wheel 4. Spindle
1
2
wheel 4. Spindle
4
3
3
4