JVC KD-X472DBT Manual De Instrucciones página 27

Bluetooth®
(for KD-X472DBT/KD-X272DBT)
[DIAL NUMBER] 1 Turn the volume knob to select a number (0 to 9) or character
( , #, +).
2 Press S / T to move the entry position.
Repeat step 1 and step 2 until you finish entering the phone number.
3 Press the volume knob to call.
[VOICE] Speak the name of the contact you want to call or the voice command to
control the phone functions. (See also the following "Make a call using voice
recognition".)
Make a call using voice recognition
1 Press and hold to activate the voice recognition of the
connected phone.
2
Speak the name of the contact you want to call or the voice command
to control the phone functions.
• Supported Voice Recognition features vary for each phone. Refer to the
instruction manual of the connected phone for details.
Store a contact in memory
You can store up to 6 contacts into the number buttons (1 to 6).
1
Press to enter Bluetooth mode.
2 Turn the volume knob to select [RECENT CALL], [PHONEBOOK] or
[DIAL NUMBER], then press the knob.
3 Turn the volume knob to select a contact or enter a phone number.
If a contact is selected, press the volume knob to show the phone
number.
4
Press and hold one of the number buttons (1 to 6).
"MEMORY P(selected preset number)" appears when the contact is
stored.
To erase a contact from the preset memory, select [DIAL NUMBER] in step 2,
store a blank number in step 3 and proceed to step 4.
Make a call to a registered number
1 Press to enter Bluetooth mode.
2 Press one of the number buttons (1 to 6).
3 Press the volume knob to call.
"NO PRESET" appears if there is no contact stored.
Bluetooth mode settings
1
Press and hold .
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3 Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
4 Press to exit.
To return to the previous setting item, press
[BT MODE]
[PHONE SELECT] Selects the phone or audio device to connect or disconnect.
" " appears in front of the device name when connected.
" " appears in front of the current playback audio device.
[AUDIO SELECT]
• You can connect a maximum of two Bluetooth phones and one
Bluetooth audio device at a time.
[DEVICE DELETE] 1 Turn the volume knob to select a device to delete, then press the knob.
2 Turn the volume knob to select [YES] or [NO], then press the knob.
[PIN CODE EDIT] Changes the PIN code (up to 6 digits).
(0000) 1 Turn the volume knob to select a number.
2 Press S / T to move the entry position.
Repeat step 1 and step 2 until you finish entering the PIN code.
3 Press the volume knob to confirm.
.
Default: [XX]
19
ENGLISH