Installation/Connection - JVC KD-X472DBT Manual De Instrucciones

Troubleshooting
Symptom Remedy
No response from Alexa Amazon cloud was unable to analyze the voice input.
after the voice input.
Wrong response from Alexa misunderstood what was said or did not catch
Alexa. the entire request or sentence spoken. Please try again.
(Page 23)
"DISCONNECTED" Be sure to connect your smartphone to the unit via
Bluetooth. (Page 16)
Not able to connect or • Be sure the audio device is connected via Bluetooth. Select
reconnect to Alexa mobile the audio device from [AUDIO SELECT] in [BT MODE].
application. (Page 19)
• Perform the one-time setup process again. See "Setup for
the first time" on page 22.
• Turn off, then turn on the unit and try to connect again.
• For iOS device, make sure ALEXA source or iPod BT source
is selected.
If you still have troubles, reset the unit. (Page 4)

Installation/Connection

This section is for the professional installer.
For safety's sake, leave wiring and mounting to professionals. Consult the car audio dealer.
WARNING
• The unit can only be used with a 12 V DC power supply, negative ground.
• Disconnect the battery's negative terminal before wiring and mounting.
• Do not connect Battery wire (yellow) and Ignition wire (red) to the car chassis or Ground wire
(black) to prevent a short circuit.
• To prevent short circuit:
– Insulate unconnected wires with vinyl tape.
– Be sure to ground this unit to the car's chassis again after installation.
– Secure the wires with cable clamps and wrap vinyl tape around the wires that come in contact
with metal parts to protect the wires.
CAUTION
• Install this unit in the console of your vehicle. Do not touch the metal parts of this unit during
and shortly after use of the unit. Metal parts such as the heat sink and enclosure become hot.
• Do not connect the
wires of speakers to the car chassis or Ground wire (black), or connect
them in parallel.
• Connect speakers with a maximum power of more than 50 W. If the maximum power of the
speakers is lower than 50 W, change the [AMP GAIN] setting to avoid damaging the speakers.
(Page 25)
• Mount the unit at an angle of less than 30º.
• If your vehicle wiring harness does not have the ignition terminal, connect Ignition wire (red)
to the terminal on the vehicle's fuse box which provides 12 V DC power supply and is turned on
and off by the ignition key.
• Keep all cables away from heat dissipate metal parts.
• After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are
working properly.
• If the fuse blows, first make sure the wires are not touching car's chassis, then replace the old
fuse with one that has the same rating.
37
ENGLISH