Faults - WIKA RTD Manual De Instrucciones

5. Commissioning, operation / 6. Faults
Increasing the distance of the connection components to hot surfaces
The length X is defined as the distance between the transition point from the cable to
the heat-emitting surface. The expected temperature at the transition point should be a
maximum of 120 °C.
▶ If necessary, the X length should be increased.
Thread

6. Faults

CAUTION!
Physical injuries and damage to property and the environment
If faults cannot be eliminated by means of the listed measures, the instrument
must be taken out of operation immediately.
▶
Ensure that there is no longer any signal present and protect against being
put into operation accidentally.
▶
Contact the manufacturer.
▶
If a return is needed, please follow the instructions given in chapter 8.2
"Return".
WARNING!
Physical injuries and damage to property and the environment caused
by hazardous media
Upon contact with hazardous media (e.g. oxygen, acetylene, flammable
or toxic substances), harmful media (e.g. corrosive, toxic, carcinogenic,
radioactive), and also with refrigeration plants and compressors, there is a
danger of physical injuries and damage to property and the environment.
WIKA operating instructions RTD and TC
Thread
(NPT)
EN
17