dirna Bergstrom bycool SPLIT Instrucciones De Montaje página 15

SPLIT
EVAPORATOR
1- Mount evaporator brackets with (4) M6 x
10 screws with allen head washer.
2- Line up evaporator unit in the most suitable
area of the cab (rear, front or side).
3- Mark evaporator fastening points.
4- Make holes of Ø 7, if they are to be through
holes or Ø 9 if M6 rivet nuts are to be used.
5- Secure evaporator with (4) 6 / 100x15 screws
with grower washers and flat washers if M6
rivet nuts are used and with (4) 6 / 100x25
screws if they are through holes by inserting
screws with flat and rubber washers through
the inside of the cab and securing on the
outside of the cab with rubber washers,
Ø 6 flat washers and M6/100 self-locking
nuts, this is done to avoid water entering the
cabin).
1
1
1
15
1
1
2
2
EN
®
1