Conformity And Approval; Setting Into Operation; Setting Up The Receiver; Connecting The Receiver - Monacor JTS UR-816DSET Manual De Instrucciones

If the units are to be put out of oper-
ation definitively, take them to a local
recycling plant for a disposal which is not
harmful to the environment
3 Applications
The transmitter UT-16GT / 1 and the receiver
UR-816D / 1 form a wireless transmission system
for musical instruments The extra compact trans-
mitter can directly be connected to the output
jack of an electric guitar or, equipped with the
supplied microphone and the clamping support, it
can be fixed e g to the bell of a wind instrument
Thus, the musician obtains a maximum freedom
of movement on stage
The wireless system transmits in the UHF
frequency range of 863 – 865 MHz on 16 fixed
channels The transmission range depends on
the local conditions and may be up to 60 m The
receiver in Diversity technology, i e with two
independent receiving antennas, ensures a reli-
able wireless transmission To suppress interfering
noise in the transmitting intervals, the system is
equipped with a noise squelch

3.1 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare
that the unit UR-816DSET / 1 complies with the
directive 2014 / 53 / EU The EU declaration of con-
formity is available on the Internet:
www jts-europe com
The unit is licence-free and generally ap proved
for operation in EU and EFTA countries
4

Setting into Operation

4.1 Setting up the receiver

The best transmission quality is obtained when
the receiver is placed at the height of the transmit-
ter (approx 1 m above the ground) and there are
no obstacles between receiver and transmitter
Place the two receiving antennas (1) in a vertical
position
For rack mounting, the 482 mm (19") installa-
tion frame DR-900SET is available as an accessory
which allows to accommodate two UR-816D / 1
units The mounting place which is not required
when using one receiver only can be covered with
the corresponding panel

4.2 Connecting the receiver

1) Connect the output of the receiver to the input
e g of a mixer, amplifier or effect unit con-
nected ahead Depending on the type of the
input, use the balanced XLR output (9) or the
unbalanced 6 3 mm jack (10)
The level at the XLR output can be attenu-
ated by 20 dB via the switch OUTPUT LEVEL (8)
for the connection to inputs for microphones
2) Connect the supplied power supply unit to the
low voltage jack "DCV INPUT 12 – 18 V" (12)
and to a mains socket (230 V / 50 Hz)
3) To prevent accidental disconnection of the plug
of the power supply unit from the jack (12),
lead the cable around the hook (11) for strain
relief

4.3 Power supply of the transmitter

The transmitter is supplied with power by a 1 5 V
battery (alkaline) of size AAA To insert the bat-
tery, open the battery compartment cover (20)
downwards When inserting the battery, observe
the polarity printed in the battery compartment
Reposition the battery compartment cover and
slide it upwards until it locks Three covers of
different colours are supplied
If the transmitter is not used for a longer
time, the battery should be removed to prevent
damage to the unit by possible battery leakage
Never put discharged batteries in the
household waste; always take them to
a special waste disposal, e g collection
container at your retailer
11