Safety Notes - Monacor JTS UR-816DSET Manual De Instrucciones

Wireless Transmission System
for Musical Instruments
These instructions are intended for users with-
out any specific technical knowledge Please read
these instructions carefully prior to operation
and keep them for later reference All operating
elements and connections can be found on the
fold-out page 3
1 Overview
1.1 Receiver UR-816D / 1
1 Receiving antennas
2 POWER switch
3 Power LED
4 Selector switch for the receiving channel
5 LED RF shows the reception of a radio signal
(red or green)
6 LED AF shows the reception of an audio signal
7 Volume control VOL
8 Selector switch OUTPUT LEVEL 0 dB /−20 dB
to adjust the level for the XLR output (9)
9 Balanced XLR output
10 Unbalanced output as a 6 3 mm jack
11 Pull-relief for the connection cable from the
power supply unit: Lead the cable around the
hook so that the plug cannot be pulled out
of the jack (12) by accident
12 Power supply jack DCV INPUT 12 – 18 V for
connection of the supplied power supply unit
1.2 Transmitter UT-16GT / 1
13 6 3 mm adapter; for connection of an electric
guitar, connect this adapter to the 3 5 mm
plug (14) of the transmitter
14 3 5 mm plug; a DC voltage is available at the
ring contact to supply the microphone with
power
15 Locking ring to tightly fasten the push-on
microphone (22) or 6 3 mm adapter (13)
16 Base to fix the clamping support (23)
17 Selector switch for the transmitting channel
18 Transmitting antenna
19 Control GAIN to adjust the input sensitivity
of the transmitter
10
20 Cover for the battery compartment
(3 pieces supplied)
21 Microphone cartridge
22 Push-on microphone
23 Clamping bracket to fix the transmitter e g
at the bell of a wind instrument
24 Momentary pushbutton ON/OFF MUTE; press
it briefly to switch on and to mute the trans-
mitter, for switching off, keep it pressed until
the status LED (25) is extinguished
25 Status LED
lights up: transmitter in operation
flashes: transmitter muted
green colour: battery o k
red colour: low battery
2

Safety Notes

The units (transmitter, receiver and power supply
unit) correspond to all relevant directives of the
EU and are therefore marked with
WARNING The power supply unit is supplied
with hazardous mains voltage
Leave servicing to skilled person-
nel only Inexpert handling or
modification of the unit may cause
an electric shock hazard
•
The units are suitable for indoor use only Pro-
tect them against dripping water, splash water,
high air humidity and heat (admissible ambient
temperature range 0 – 40 °C)
•
Immediately disconnect the power supply unit
from the mains socket if
1 there is visible damage to the units or to the
mains cable,
2 a defect might have occurred after a drop or
similar accident,
3 malfunctions occur
The units must in any case be repaired by skilled
personnel
•
For cleaning only use a dry, soft cloth, never
use chemicals or water
•
No guarantee claims for the units and no liability
for any resulting personal damage or material
damage will be accepted if the units are used
for other purposes than originally intended, if
they are not correctly connected or operated,
or if they are not repaired in an expert way