Preparing For Saw Operations - Bosch TC10 Instrucciones De Funcionamiento

BM 2610019162 10-11:BM 2610019162 10-11.qxp 10/20/11 8:59 AM Page 19
B. Pull out the table lock to insert the locking pin
into one of the holes: the work table is locked
in position on the rails.
5. Remove all Extension Water Trays and set aside.
6. Remove the Extension Work Table, turn it upside
down and secure it to the Sliding Work Table
(Fig. 27).
A. Align the hole in the extension table with the
hole in work table.
B. Pull out the pin attached to the extension table
and lock the extension table on the sliding
work table by inserting the pin into the holes
To avoid possible injury, discon-
WARNING
nect plug from power source be-
fore performing any assembly, adjustments or
repairs.
To reduce the risk of electrocu-
WARNING
tion, keep all connections dry
and off the ground. Do not touch plug with wet
hands.
location
Use the tile saw in a well lit area and on a level
surface, clean and smooth enough to reduce the
risk of trips and falls. Use it where neither the op-
erator nor the casual observer is forced to stand in
line with the blade.
To avoid the possibility of the appliance plug or re-
ceptacle getting wet, position tile saw to one side of
a wall mounted receptacle to prevent water from
dripping onto the receptacle or plug. The user
should arrange a "drip loop" in the cord connecting
the saw to a receptacle. The "drip loop" is that part
of the cord below the level of the receptacle, or the
Transporting and Mounting

preparing for Saw Operations

-19-
Mounting
NOTE: If you have purchased a Bosch Wet Tile Saw
Stand, please see the manual that accompanies the
stand for proper mounting instructions.
connector if an extension cord is used, to prevent
water traveling along the cord and coming in contact
with the receptacle (Fig. 28).
To reduce the risk of electrocu-
DANGER
tion, DO NOT unplug the cord if
the plug or receptacle gets wet. Disconnect the
fuse or circuit breaker that supplies power to the
tool. Then unplug and examine for presence of
water in the receptacle.
POWER
SUPPLY
CORD
DRIP
LOOP
FIG. 27
FIG. 28
TILESAW
TILESAW
SUPPORT