Bosch TC10 Instrucciones De Funcionamiento página 8

BM 2610019162 10-11:BM 2610019162 10-11.qxp 10/20/11 8:59 AM Page 8
19
18
8
24
12
10
1. ON/Off Switch – Energizes the unit.
2. Blade Guard – The blade guard is a safety de-
vice. It can be opened or closed by turning the
knob on the blade guard. Make sure that the
blade guard is locked before cutting.
3. Blade Guard lock Knob – Twist to lock and
unlock blade guard door for changing blades.
4. Spindle lock – Press the spindle lock to keep
the shaft from rotating while changing the saw
blade.
5. Blade – Use 10" (254 mm), 8" (203 mm)
6. Universal Guide – Quick set up for 0°, 22.5°
and 45° cuts.
7. Table lock – Locks sliding work table in two
positions for storage or under the blade for
plunge cutting below the blade.
8. Sliding Work Table – The work platform can
be moved along the rails.
9. Extension Work Table – Attaches to the work
table to support large workpieces.
Getting to Know Your Wet Tile/Stone Saw
21
1
15
4
7
13
22
23
20
14
3
5
6
10. Sliding Work Table Stop – Provides hard stop
for sliding work table.
11. Rails – The sliding work table moves along the
two rails when cutting a workpiece.
12. frame – The base of the wet tile saw.
13. Water Tray – Holds the water needed to cool
the blade and features drain plug to empty.
14. Anti-Splash Guard – Minimizes the over-spray
and mist when cutting.
15. Wrench Storage Clips – Conveniently holds
the nut wrench and hex wrench when they are
not in use.
16. Rear Extension Water Tray – Catches over-
spray from large tile and redirects water into the
tray.
17. Side Extension Water Tray System – Catches
water dripping from sides of tile and redirects
water into the tray.
18. Support Arm – Supports the motor unit on the
frame.
-8-
2
16
11
17
9