Motor Specifications - Bosch TC10 Instrucciones De Funcionamiento

BM 2610019162 10-11:BM 2610019162 10-11.qxp 10/20/11 8:59 AM Page 6
"READ ALL INSTRUCTIONS" — Failure to follow the SAFETY RULES identified by
WARNING
BULLET (•) symbol listed BELOW and other safety precautions, may result in serious
personal injury.

Motor Specifications

• In the event of a malfunction or breakdown,
grounding provides a path of least resistance for
electric current to reduce the risk of electric shock.
This tool is equipped with an electric cord having
an equipment-grounding conductor and a ground-
ing plug. The plug must be plugged into a matching
outlet that is properly installed and grounded in ac-
cordance with all local codes and ordinances. This
saw is wired for operation on 110-120 volts, 60 Hz.
alternating current. Before connecting the motor
cord to power source, make certain the switch is
in the "OFF" position and be sure the electric cur-
rent is of the same characteristics as stamped on
the tile saw nameplate.
Connection To A power Source
• This machine must be grounded while in use to
protect the operator from electric shock.
• Plug power cord into a 110-120V properly
grounded type outlet protected by a 15-amp dual
element time delay fuse or circuit breaker.
• Not all outlets are properly grounded. If you are not
sure that your outlet, as pictured on this page, is
properly grounded; have it checked by a qualified
electrician.
To avoid electric shock, do not
DANGER
touch the metal prongs on the plug
when installing or removing the plug to or from the
outlet.
Failure to properly ground this
DANGER
power tool can cause electrocution
or serious shock, particularly when used near metal
plumbing or other metal objects. If shocked, your re-
action could cause your hands to hit the tool.
Safety
immediately to avoid shock or fire hazard.
a green jacket and is attached to the tool housing at
one end and to the ground prong in the attachment
plug at the other end.
• If the outlet you are planning to use for this power
tool is of the two-prong type, DO NOT REMOVE
OR ALTER THE GROUNDING PRONG IN ANY
MANNER. Have a qualified electrician replace the
TWO-prong outlet with a properly grounded
THREE-prong outlet. Do not use any adapter
plugs.
• Improper connection of the equipment-grounding
conductor can result in a risk of electric shock. The
conductor with insulation having an outer surface
that is green with or without yellow stripes is the
equipment grounding conductor. If repair or re-
placement of the electric cord or plug is necessary,
do not connect the equipment grounding conductor
to a live terminal.
• Check with a qualified electrician or service per-
sonnel if the grounding instructions are not com-
pletely understood, or if in doubt as to whether the
tool is properly grounded.
"SAVE THESE INSTRUCTIONS"
-6-
If power cord is worn, cut or dam-
DANGER
aged in any way, have it replaced
• Your unit is for use on 120
volts and is equipped with a 3-
conductor cord and grounding
type plug, approved by Under-
writers Laboratories and the
Canadian Standards Associa-
tion. The ground conductor has