Technical Specifications - cecotec CONGA 1190 Serie Manual De Instrucciones

05 The remote control
does not work (the
operation radius is
5 meters)
Note:
If none of the solutions solve the problem, try the below steps:
1. Switch off and switch back on the robot.
2. Contact the Technical Support Service of Cecotec.

7. TECHNICAL SPECIFICATIONS

Model: Conga Serie 1190
Product reference: 05133/05134/05135
100-240 V, 50/60 Hz
Battery: 14.4 V, 2600 mAh
Made in China | Designed in Spain
The remote control's
battery is low
The robot is turned off
or the battery is low
The remote control's
infrared transmitter or
the robot's reception
sensor is dirty and
cannot send or receive
any signal
There is equipment
nearby which can
produce infrared
signals.
ENGLISH
Replace the batteries
with new ones
Make sure the power
switch is on and that
the battery is full
Clean the remote
control's infrared
transmitter and the
robot's reception
sensor with a soft
cloth
Avoid using the
remote control around
equipment which
can produce infrared
signals
45