aldes Dee Fly Instrucciones De Montaje página 15

Ocultar thumbs Ver también para Dee Fly:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 36
Wall MOUntinG (boiler)
Water trap for boiler type:
Condensate connection
• Screw the evacuation nozzle into the product at the release level
• A water trap having H=50 mm min. must imperatively be used
• Connect the evacuation nozzle to the 32 diameter water trap with a sufficient and regular slope
• before starting up fill the water trap with water
• Place the condensate evacuation in a frost free zone if necessary
Boiler mounting
The motor, heat exchanger and bypass (option) are
supplied pre-assembled. A mounting kit comprising
2 wall-mounting angles is supplied.
• Drill into the wall as per the diagrams below
• Insert adequate wall plugs
• Fix the 2 wall-mounting angles with screws
• Hook the equipment onto the mounting angles.
• For the collection of condensates, install the
condensate evacuation nozzle as shown opposite,
to the exchanger release
.
28
riGiD DUCt assEMBlY
Ductwork in heated spaces: using rigid
circular ductworks or miniducts
Strongly recommended for thermal efficiency reasons.
Use of miniduct ducts and accessories in order to facilitate
the integration of the ductwork into the heated spaces and
limit pressure losses.
Screwed in at two
Single screw with duct
points
clipped into the bracket
Flat duct 40x100
PVC Adhesive
Plug
Flat duct
40x100
60x200
Grille connections
The grilles should be connected to the miniduct network using an appropriate miniduct/grille connector
Flat duct
Vertical band 90°
Flat duct
100 x 40
for grilles
200 x 60
BIO Design Ø 80
RF Ø 125
Manchette
Direct connection using the miniduct range elbow bends
trident Ø 125
Connection using the appropriate accessories when it is too far
from the ductwork to the grille
BAHIA
Ø 125
Duct mounting and connections
Use the flange.
To interconnect the miniducts and
provide a good seal, use PVC tape or
compatible adhesives.
Distribution casing
Use of the flat 3 or 6 connector distribution casing
• Connections using miniducts
• Integrates into suspended ceiling voids
• H < 100 mm
• Mounting the distribution casing to the ceiling using threaded studs
Vertical band 90°
for grilles
BAP'SI
Ø 125
29

Publicidad

Tabla de contenido
loading

Tabla de contenido