Instructions For Installation Of Frigoclic Fittings - Dometic 8883000200 Instrucciones De Montaje

Frigo
4 Instructions for installation of FRIGOCLIC
fittings
A
CAUTION!
z Only use the mounting pliers suitable for the task when installing FRIGO-
CLIC fittings!
z Check the clamping bush for correct locking following installation!
z Replace the hose clamps and the O-rings when reusing the fittings!
z Always remove the used end of the hose with the hose cutters!
z Ensure that hose ends always have a straight cut!
1
4
➤ Cut the hose end off with a straight cut using hose cutters (fig. 1).
➤ Slide the clamping bush onto the hose end. Position the clamping bush fully on to the
hose end until it stops (fig. 2).
➤ Apply refrigerant oil to the O-rings and the inside of the hose end and insert the fitting
into the hose end (fig. 3).
➤ Ensure that the clamping bush is fully on the hose end when clamping.
➤ Clamp the clamping bush on top (fig. 4 1).
➤ Clamp the clamping bush on the bottom (fig. 5 2).
10

Instructions for installation of FRIGOCLIC fittings

2
5
3