Configuring The Direct Panel; Configuring The Different Parameters - Fermax DIRECT DUOX Manual De Instalador

DUO DUO X DIRECT X DIRECT
DUO DUO DUOX DIRECT X DIRECT X DIRECT
DUO DUO DUOX DIRECT X DIRECT X DIRECT X DIRECT
DUO DUO X DIRECT

Configuring the Direct Panel

The street panel´s parameters can be programmed on the keypad.
For this you must enter in configuration mode via a programming access code after
pressing 'A'.
Programming Access code: A + 4444 (default code).
If the code is correct, a confirmation tone sounds (beep-beep).
The parameters that can be configured are:
Position Adjustments
Parameter
Activation time
01
lock-Releases
Exit button
02
activation time
Panel type
03
04
Block number
05
Sub-Block num.
06
Panel number
07
Door Sensor Time
Opening code
08
09
Programming
Code
10
MASTER panel
11
Mode
Guard Unit
12
Monitoring volume
RESETTING
13
Parameters

Configuring the different Parameters

You can configure a parameter by entering the two position digits; you will then hear a
beep and then you must enter the desired value (1, 2, 3 or 4 digits relative to the parameter).
If the code is correct, a confirmation tone sounds (beep-beep) and the new value is
Pag 48
Comments
Possible Values
[ ]
default
01-99'' Open-door relay activation from the phone or
[03] access´ control.
01-99'' Activating lock-release relay from the exit button
[06] (connected to the 'Bs' and '-' terminals).
0:
Sub-Block
[1]:
Block
Configuration of the panel type.
2:
E. General
00-99
Block number the panel belongs to.
[00]
00-99
Sub-Block number the panel belongs to.
[00]
0-9
Panel number.
[0]
000-250
Maximum time the door can be left open after
[000]
not active
the lock-release.
0000-9999
Opening code from the keypad. The opening
[AAAA]
not active
code is entered as follows:
A + XXXX (4 digits).
Programming Access code.
0000-9999
[4444]
[0]: No
Activating the panel as MASTER to program
1 : Yes
telephones.
[0]: No Reset
Reset to night mode by writing «1» in this
1 : Reset
position.
0-9
Adjust street panel monitoring volume
[5]
[0]: No Reset
Reset to the default values by writing «1» in this
1 : Reset
position.