Resetting The Programming Access Code (If The Previous One Is Forgotten); Configuration Of The Street Panel With Buttons (With No Keypad) - Fermax DIRECT DUOX Manual De Instalador

DUO DUO X DIRECT X DIRECT
DUO DUO DUOX DIRECT X DIRECT X DIRECT
DUO DUO X DIRECT X DIRECT
DUO DUOX DIRECT DUO X DIRECT X DIRECT
saved. If not correct you will hear the error sound (beep-bop).
Position
00 ... 12 (beep) +
Examples:
•
Change the programming code to 1122:
09 (beep) 1122 (beep-beep)
•
Changing the lock-release time to 2 seconds:
01 (beep) 02 (beep-beep)
In order to exit the programming press 'A' when we are entering the menu´s position
number. You can also exit by waiting 60 seconds without pressing any key.
NOTES:
- If trying to assign the same programming code as the lock-release code, it is not
allowed and a call error tone sounds (beep-bop).
-To deactivate the opening code you must enter the value AAAA in position 08
- When configuring a zero value in «Volume Monitoring" you mute the button, call,
and other monitorings of the street panel.

Resetting the programming access code (if the previous one is forgotten)

If you have changed the programming access code (if the previous one is forgotten), you
may restore the default code.
Carry out the following steps:
1. With the power supply disconnected, short circuit the «Bs» and «-» (negative) ampli-
fier terminals
2. Maintaining the short-circuit induced above, connect the system's power supply (at
this point it will no longer be necessary to maintain the short circuit or hold down the
button). The default code is now restored: 4444.
NOTE:
- If you happen to assign the door´s lock-release code the same code as that of the
default programming entrance code, when restoring the programming access you
immediately deactivate the lock-release access code. This is because you can not
have the same code in both programming parameter fields.

Configuration of the street panel with BUTTONS (with no keypad)

You can not configure the buttons panel alone, since it does not have a keypad for entering
the numeric values. For this you must temporarily connect a keypad (ref. 7439) to modify
said parameters.
See «Configuring the Direct Panel» on the previous page.
See the keypad connection diagram on the next page.
Possible Values
1, 2, 3 or 4 digits (beep-beep)
(or press the exit button when one exists).
(digits relative to the selected parameter).
Pag 49