Flotec FPCC5030 Manual Del Usuario página 5

Installation • Operation
6. Once the Combo Kit is firmly seated in the base of the
pit, connect the hose and clamp switch to the existing
discharge pipe and clamp it securely.
7. Secure power cord (PSP & BSP), piggyback switch,
and reed switch cord high up and around pipe with
a cable tie. Plug the primary pump into a standard
household 15 amp outlet.
NOTICE The circuit should be dedicated to the sump
pump exclusively.
Remember: Do not handle the pump while it is
plugged in; whether it is running or not.
8. Connect BBU. See "BBU Wiring and Setup".
9. Once all wiring is complete, fill your pit with water
4827 0916d
10. Make sure that the power is on to both pumps, and
Operation
not handle a pump or pump motor with wet hands or when
standing on wet or damp surface, or in water.
1. Shaft seal depends on water for lubrication. Do not
2. Motor is equipped with automatic reset thermal
3. Pump will not remove all water. If operating a pump
6615 0916c
Before attempting to check why unit has stopped
operating, disconnect power from unit.
and verify that the PSP removes the water and the
BBU doesn't run. Then, unplug your PSP and refill
your pit with water. Verify that the BBU removes the
water.
your system is ready to use.
Risk of electric shock. Can shock, burn or kill. Do
operate pump unless it is submerged in water as seal
may be damaged if allowed to run dry.
protector. If temperature in motor should rise, switch
will cut off all power before damage can be done
to motor. When motor has cooled, switch will reset
automatically and restart motor. If protector trips
repeatedly, pump should be removed and checked.
Low voltage, long extension cords, clogged impeller,
very low head or lift, or a plugged or frozen discharge
pipe, etc., could cause cycling.
manually and suddenly no water comes out of the
discharge hose, shut off the unit immediately. The unit
has broken prime due to a very low water level.
Risk of electric shock. Can shock, burn or kill.
5
6615 0916d