KREA Swiss hotCHOC Manual De Instrucciones página 7

Ocultar thumbs Ver también para hotCHOC:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

4. CLEANING
IMPORTANT: Always remove the electrics and heating unit before
washing the gun. These parts should never be exposed to liquids. Always
clean immediately after use.
For external cleaning, simply wipe down the outside of the sprayer with a
dish soap. For internal cleaning, we recommend to spray half a container
of very hot water through and then clean the individual parts using a
suitable dishwashing detergent. Careful use of a soft pipe cleaning brush
is also recommended. Care should be taken not to damage the cylinder
by using abrasive or sharp tools. If available, blowing air through the
nozzle and suction tube can ease the cleaning process. Rinse thoroughly
thereafter with hot clean water.
The sprayer is designed with quality components. If you experience any
issue, we recommend first following the trouble shooting document and
film available on our website:
has been forgotten or the product needs a thorough cleaning. If your
issue persists, please contact your reseller for additional support. Please
always include the article number (page 33) in any correspondence.
DISMANTLING AND ASSEMBLING (see page 33)
• Unscrew the round jet nozzle (9) and slide off the nozzle heating unit (14)
• Then unscrew the bent nozzle extension (8) from the pump housing (5).
• Remove the 3 piece "atomiser unit" (7) from inside the chamber. The
metal adapter (6) should never be removed. Place all parts in a small
dish and clean them following the cleaning steps outlined earlier. The
suction tube (10), container (11), container insulation sleeve (12) and
nozzle insulation sleeve (13) can be washed in the sink.
• Remove the service screw (2) and take off the pump housing (5). Put
the piston (3), piston spring (4) and hood (1) to one side and wipe
them down as outlined above.
• To assemble the gun, do so in reverse order.
• The piston should move freely in the pump housing.
• Ensure the service screw, bent nozzle extension and round jet nozzle
pieces are all screwed on tightly.
www.kreaswiss.com.
7
In most cases a part

Publicidad

Tabla de contenido
loading

Productos relacionados para KREA Swiss hotCHOC

Tabla de contenido