Zanussi ZWG1121 P Manual De Instrucciones página 6

Installation
Unpacking
Important!
All transit bolts and packing must be
removed before using the appliance.
You are advised to keep all transit devices so
that they can be refitted if the machine ever has
to be transported again.
Using a spanner
unscrew and
remove the two
rear bottom
screws.
Slide out the two
plastic pins.
Lay the machine on its back ensuring that
the hoses are not crushed.
Place one of the
polystyrene angle
packings under
the machine.
Remove the
polystyrene block
(A) protecting the
motor.
6
A
Remove the polystyrene base, set the
machine upright and unscrew the remaining
rear screw. Slide
out the relevant
pin.
Cover all the open holes with the plugs which
you can find in the bag containing the
instruction booklet.