Peaq PDR260-B Manual De Instrucciones página 38

ENGLISH
Connections
POWER SUPPLY (Q)
Connect the DC connector of the adaptor
to the DC IN-jack. Plug the adaptor to a
power socket.
AUX-IN (O)
You can also listen to external audio de-
vices by connecting the cable (not includ-
ed) to the AUX-IN jack at the back of the
product.
USB CONNECTION (P)
Playback of music files
You can playback music files which are
saved on an USB stick by plug in the USB
stick.
Charging external devices
External devices can be charged via USB
port on the unit. Connect the device to the
USB port (output: 5 V/ 1000 mA).
LAN CONNECTION (M)
Socket of LAN / Ethernet cable connection
for the cable connection of the device with
the cable-connected home network.
HEADPHONE CONNECTION (N)
Connect the headphones to the Head-
phone jack of the device.
Attention
Danger! Excessive sound pressure levels
from ear buds and headphones can cause
hearing damage. Listening to loud music
for extended periods of time may lead to
hearing impairment. Keep the volume at
reasonable levels.
38
_PDR260_171222_A_V06_HR.indb 38
INSERTING BATTERY (25)
Slide the battery compartment cover in the
direction of the arrow and pull it out. Insert
the new battery (CR2032, 3 V
ing attention to correct polarity. Slide the
battery compartment cover back on and
let it snap into place.
Note
The battery is already inserted. Remove
the battery protection strip before first use.
Operation
TURNING THE UNIT ON
Press the button to switch on the unit.
Note
If you turn on the product for the first time,
the Setup Wizard will call up automati-
cally. Follow the on screen instructions to
make the first time set up.
Setting the display language
Press the MENU button and select Sys-
tem settings. Then select Language and
the desired language, e.g. English. Press
SELECT button to confirm the setting.
ADJUSTING THE ANTENNA (R)
For optimal reception, extend the antenna,
move to fully extend and adjust it.
ADJUSTING THE VOLUME
The volume can be adjusted during play-
back with the volume control.
Internet-Radio Configuration
There are two ways to connect the radio to
the internet using an access point:
• Wireless in WLAN-Mode
The WiFi-antenna of the radio receives
your DSL router signals
• With cable using the radio's LAN con-
nection in LAN-Mode
Provided an ethernet network is available.
Only use shielded LAN cable.
) , pay-
22/12/17 12:37 pm