Peaq PDR260-B Manual De Instrucciones página 39

WLAN-MODE CONFIGURATION
If you have a wireless network, the WLAN
mode is the direct way to connect your ra-
dio to the Internet:
1. Simply switch the radio on and, as a
cable-free network client, it automati-
cally searches all available APs (Access
Points).
2. When switching on for the first time,
you must confirm the AP and perhaps
enter the key. For doing so please fol-
low instructions of below chapters.
After that, the radio will always access
this AP. If the AP can no longer be
found, it will be registered accordingly.
LAN CONFIGURATION
If you do not have a wireless network but
do have a cabled network, you can con-
nect the Internet radio with a network.
1. Switch the radio off.
2. Connect an Ethernet cable to the LAN
socket. Once switched on and choose
wired. The radio will automatically be
recognized as a cable client.
Note
Only use the provided shielded LAN net-
work cable for internet connection via LAN.
If the delivered shielded LAN network ca-
ble is not available anymore, please pur-
chase a new shielded LAN network cable
for the internet connection via LAN.
WLAN-REGION AND WLAN-NETWORK
Select the WLAN-Region in which you are
located. The device then looks for available
wireless networks. If a wireless network is
not found, the device shows the notifica-
tions [Rescan] [Wired] [Manual config].
Please check in this case whether your
router and WLAN are switched on.
_PDR260_171222_A_V06_HR.indb 39
Note
Make sure that the DHCP-server of your
router (Access Point) is activated. Other-
wise, the WLAN connection must be con-
figured manually. The WLAN should send
out the SSID. If the SSID is not sent out,
you must configure the WLAN manually.
• Select the network from which you want
to operate Internet radio.
PUBLIC NETWORK CONNECTION
Select the appropriate WLAN-network
by clicking on the entry of the network's
name. The connection procedure takes
place automatically.
Note
In the Systems settings > Setup wizard,
you can manually configure the network.
PRIVATE NETWORK CONNECTION
Select WPS connection type
If a network is protected by a WEP or WPA
encryption, the query for constructing a
connection over WPS (Wi-Fi Protected
Setup) appears. If the router of your wire-
less network has a WPS function, select
whether the WPS connection should be
established by entering a PIN code over
the WPS key on the router.
WPS connection using PIN entry
A WPS-PIN appears in the Internet radio
display. Enter this PIN and confirm the In-
ternet radio with OK. The WPS connection
will then be established.
Connection using WPS key
Press the WPS key on the router and then
confirm the display on Internet radio with
SELECT. The WPS connection is then es-
tablished.
ENGLISH
39
22/12/17 12:37 pm