Peaq PDR260-B Manual De Instrucciones página 42

ENGLISH
CHANGING DAB/DAB+ STATIONS
1. Press
available DAB/DAB+ stations.
2. The selected station is played auto-
matically.
SEARCHING DAB STATIONS
Press the button MENU and select "Scan"
with the turning knob or
Press SELECT to confirm.
The unit scans all available DAB/DAB+ sta-
tions and plays the first available station.
Note
New stations and services are added to
the stored DAB/DAB+ stations. In order
to make new DAB/DAB+ stations and ser-
vices available on your radio, run a full scan
at regular intervals.
DISPLAYING STATION INFORMATION
1. Select a DAB station.
2. During DAB/DAB+ radio playback,
press INFO repeatedly to display the
following information (if available):
• DLS
• Programme Type
• Ensemble/Frequency
• Signal error/Strength
• Bit rate/Codec/Channels
• Date
USING THE DAB/DAB+ MENUS
In DAB mode press MENU and browse
the menu options with
ing knob VOLUME/SELECT/SNOOZE.
To confirm your selection press SELECT
every time.
1. Station list
All existing stations are listed. To
delete the unavailable stations, go to
step 4.
42
_PDR260_171222_A_V06_HR.indb 42
/ in DAB mode to navigate
/ buttons.
or the turn-
/
2. Scan
Searches for all available DAB/DAB+
stations.
3. Manual tune
Manual tuning adjustment, for exam-
ple aligning the antenna or adding
stations.
4. Prune invalid
Removes all invalid stations from the
station list.
5. DRC
6. Station order
Alphanumeric
Ensemble
Valid
7. System
8. Main menu
FM radio
SELECTING FM STATIONS
1. Press MODE to select FM stations.
2. The radio plays the last station se-
lected.
SELECTING FM STATION FREQUENCIES
1. Select a FM station.
2. Manual frequency selection.
Press TUNING to change the
frequency at intervals of 0.05 MHz.
3. Automatic frequency selection.
Press and hold one of the buttons
/ and the radio will stop search-
ing once an active station has been
found.
STORING FM STATIONS
You can store up to 10 preset FM stations.
1. Select the desired FM station.
2. Press and hold MEMORY until "Save
to Preset" appears.
3. Press / to preset a number from
1 -10. Press SELECT to confirm the
selection.
4. The preset number of the stored
station is displayed.
22/12/17 12:37 pm