Aux Mode; Cleaning And Care - Peaq PDR260-B Manual De Instrucciones

ENGLISH

AUX Mode

1. Connect the audio cable (not included) into the AUX IN jack (3.5 mm) at the rear side
of the device.
2. Press MODE to select AUX as a source.
3. Start playing from the device.
Attention
Check the safety and user instruction of the external device before connection.

Cleaning and Care

• Always pull the power plug from the power outlet before cleaning.
• Caution! Water must not enter the device.
• Clean the housing with a slightly damp cloth.
• Do not use any sharp, abrasive or aggressive cleaning agents.
• Do not use any chemicals (e.g. gas, alcohol) to clean the housing.
Troubleshooting
If there are any problems during operation, please refer to the following table. If problems
cannot be solved as indicated under Solution, please contact your manufacturer.
Problem
Product does not
function
NO Sound
USB drive can't be
read
Poor radio reception
quality
Remote control does
not function
46
_PDR260_171222_A_V06_HR.indb 46
Possible causes
• Interrupted power supply
• Volume is very low
• External device is muted
• USB drive defect
• Data format not support.
• Poor radio reception
• Battery in remote control
empty
Solution
• Check the power supply
• Adjust the volume
• Check and turn off mute
on the external device.
• Insert a new USB drive
• Check the data format
• Place the product to
another place and adjust
the antenna again.
• Replace battery in
remote control
22/12/17 12:37 pm