Assisted Procedure; Recovery And Recycling - Sun BREEZE II Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 148

ASSISTED PROCEDURE

In the assisted procedure mode, all the operations can be performed singly to the exception of
the recovery/recycling phase, which is automatically followed by used oil discharge. The values
for the quantity of gas recovered, quantity of oil recovered, vacuum time, quantity of oil
reintegrated, and quantity of gas charged into the system are automatically printed at the end
of each single operation.
From the MAIN MENU:
Select ASSISTED PROCEDURE and press the ENTER key.
The following screen is displayed:
NOTES:
*
Only if the hardware is installed in the machine.
xy
Default values extrapolated from a previous procedure.

RECOVERY AND RECYCLING

Press ENTER to confirm RECOVERY / RECYCLE.
The following screen is displayed:
Key in the vehicle's licence plate using the ↓↑ arrows to move around the licence plate
number. Then press "ENTER" to confirm.
NOTE: The numerical keys include an alphabet similar to that for text messages, for example:
press "2" once to display "A", twice to display "B", three times for "C" and four time for "2".
The following screen is displayed:
Open the high and low pressure taps on the machine and press START to start the refrigerant
recovery/recycle phase.
INSTRUCTIONS MANUAL
AUTOMATIC PROCEDURE
<ASSISTED PROCEDURE>
DATA AND CONFIGURATION
MAINTENANCE
xx.x kg
RECOVERY / RECYCLE
VACUUM
xy min
FILLING
xy g
SYSTEM FLUSHING*
CHANGE OIL TYPE
Enter licence plate
............
Premere ENTER
Open high and low
pressure then
Press START
During this phase the display shows the quantity of refrigerant
-15-

Publicidad

Tabla de contenido
loading

Tabla de contenido