Installation Declaration - RK Rose+Krieger PLM-II Instrucciones De Montaje

1.1 Installation declaration

As set out in Machine Directive 2006/42/EC, Appx. II, 1.B for incomplete machines
Manufacturer
RK Rose+Krieger GmbH
Potsdamer Straße 9
D-32423 Minden
confirms that the named product
Mat:
AB:
Pos:
SN:
ID no.:
Bj:
complies with the requirements for an incomplete machine according to EC machine directive
2006/42/EC.
The following basic requirements of Machine Directive 2006/42/EC as set forth in Appendix 1 are
applied and met:
1.1.5.; 1.1.7.; 1.3.; 1.3.2.; 1.3.3.; 1.3.4.; 1.3.7.; 1.3.9.; 1.5.8.; 3.2.1.; 3.4.4.; 4.1.2.1.; 4.1.2.3.;
4.1.2.4.; 4.1.2.5.; 4.1.2.6.a), 4.1.2.6.b); 4.1.2.6.c); 4.1.2.6.d); 4.1.2.6.e); 4.1.3.; 4.2.1.; 4.2.1.4.;
4.2.2.; 4.2.3.; 4.3.1.; 4.3.2.; 4.3.3.; 4.4.1.; 4.4.2.; 6.1.1.; 6.3.3.; 6.4.1.; 6.4.3.
The following harmonising standards were applied:
DIN EN ISO 12100 – 1
DIN EN ISO 12100 – 2
DIN EN ISO 14121 – 1
RK Rose+Krieger undertakes to deliver the technical documents for an incomplete machine as set
out in Appendix VII B to Directive 2006/42/EC on request from the national agencies with a jus-
tified request in electronic form.
Under the supervision of the document manager
Minden / 29.12.2009
Place / Date
Commissioning is forbidden until the machine in which this incomplete machine is incorporated
complies with the provisions of EC Directive 2006/42/EC.
Before bringing into service, this must comply with EC directives, including documentation.
Minden / 29.12.2009
Place / Date
see maker's plate on the front page of these installation instructions
see maker's plate on the front page of these installation instructions
see maker's plate on the front page of these installation instructions
see maker's plate on the front page of these installation instructions
see maker's plate on the front page of these installation instructions
see maker's plate on the front page of these installation instructions
Machine safety - Basic definitions, general design guidelines Part 1: Basic
terminology, system engineering
Machine safety - Basic definitions, general design guidelines Part 2:
Technical guidelines and specifications
Machine safety – Risk assessment – Part 1 Guidelines
Signature
Signature
1. Installation declaration
Technical Manager
Signatory information
Managing Director
Signatory information
27