Use/Operators; Proper Use; Improper Use; Reasonably Predictable Improper Use - RK Rose+Krieger PLM-II Instrucciones De Montaje

4. Use/Operators

4.1 Proper use

The linear unit must be used exclusively for a linear process and positioning of workpieces, units,
measuring devices or for other comparable setting tasks in industrial plants.
The linear unit should not be used in areas where there is a risk of explosion or in direct contact
with foodstuffs, pharmaceutical or cosmetic products.
Catalogue information, the contents of these installation instructions and conditions laid down in
the order are to be taken into account.
The loading information given in these installation instructions shows maximum values and these
must not be exceeded.

4.2 Improper use

Improper use means that the information quoted in section 4.1 Proper use is not being observed.
In the event of improper use, incorrect action and if this linear unit is used, installed or handled by
untrained personnel, this linear unit may pose risks for them.
If this linear unit is used improperly, then RK Rose+Krieger GmbH ceases to be liable and its gen-
eral operating licence will be void.

4.2.1 Reasonably predictable improper use

•
Use in an environment where these is a risk of explosion (if used in explosive areas sparks can
lead to detonations, fire or explosions)
•
Use of the linear unit with permitted forces/torques exceeded
•
inadequate securing of the linear unit
•
inadequate securing of the loads to be moved
•
Loads which exceed the quoted limits
•
Use in the food processing industry with direct contact with unpacked foods
•
Use in the open air
•
Use in an environment with air humidity > dewpoint
•
Use in a heavily contaminated environment
•
Use in extremely dusty atmospheres
•
Use in an atmosphere containing solvents
•
Processing of living organisms
•
Use in liquids

4.3 Who can use, install and operate this linear unit

Individuals who have read and understood the installation instructions completely can use, install
and operate this linear unit. Responsibilities for handling this linear unit must be clearly laid down
and obeyed.
30