Product Information; How It Works; Designs/Guidance Concept; Designs - RK Rose+Krieger PLM-II Instrucciones De Montaje

6. Product information

6.1 How it works

The linear unit is used for linear processing and positioning. The slots are driven into their posi-
tions by a tapped spindle drive. This motion can be effected manually with a rotating knob, a
handwheel or by an electric drive. A slide controls the slides free from play on an extruded section
with lateral prismatic guides.

6.2 Designs/Guidance concept

This linear unit is available in the designs and guidance versions given here.
•
After receiving this linear unit, check the device for possible damage and missing components.
•
Notify RK Rose+Krieger GmbH of any faults found immediately.
The linear unit is delivered ready for operation, but without a controller and without accessories.

6.2.1 Designs

PLM-II linear unit
Design with spindle (fine-thread spindle)
PLM-GII linear unit
Design without drive
Spindle versions:
•
Right-hand thread
•
Left-hand thread
•
Right/left hand thread
•
Divided spindle
34