Fermax MONITOR iLOFT BUS2 Manual De Instalador página 24

iLOFT Monitor iLOFT Monitor
iLOFT Monitor iLOFT Monitor
PROGRAMMING OF THE iLOFT MONITOR
1. Select programming mode:
(5 sec.)
With the monitor connected:
- Press and hold the «MENU» button for 5 seconds. The tone pre-programmed on
the main panel will sound.
- Press and hold the «F1» and «F2» buttons simultaneously for 3 seconds. The
confirmation tone will sound, the monitor screen will be activated and will show its
current address in the box.
The blue led on.
2. Programme the monitor's address from the Monitor
2.1- Press the corresponding button for hundreds, tens or units to increase the
corresponding digit by that unit (appears on screen):
000
2.2- Press the «F2» button until you hear the confirmation sound.
2.3- Confirm address: press and hold the «F1» and «F2» buttons simultaneously for
3 seconds until you hear the confirmation tone.
If 90 seconds elapse without you having confirmed the selected address, the monitor
will remain programmed with the last address stored before entering programming
mode.
Page 24
(3 sec.)
Hundreds: Press the button
Tens: Press the button
Units: Press the button
as a SECONDARY
F1 F2
+
Once you reach 9 pressing the
button again will return you to
0 and an error tone will sound.
The next time you press the
button it will start from the
number 1.
000