Programming The Monitor - Fermax MONITOR iLOFT BUS2 Manual De Instalador

iLOFT Monitor iLOFT Monitor
iLOFT Monitor iLOFT Monitor
PROGRAMMING THE iLOFT MONITOR
1. Select programming mode:
Option 1:
(5 sec.)
With the monitor connected:
- Press and hold the «MENU» button for 5 seconds. The tone pre-programmed on
the main panel will sound.
- Press and hold the «F1» and «F2» buttons simultaneously for 3 seconds. The
confirmation tone will sound, the monitor screen will be activated and will show its
current address in the box.
The blue led on.
Option 2:
With the monitor connected:
- Press and hold the «PROG» button for 1 second. The monitor's screen will be
activated and show its current address in the box.
The blue led on.
Page 22
(3 sec.)
3 sec.
F1 F2
+
000
000