Fermax MONITOR iLOFT BUS2 Manual De Instalador página 27

iLOFT Monitor
iLOFT Monitor
Operation
x 3
2 sec.
+
sn3
Canceling the Ring Tone
With the monitor on standby, press the
consecutively in less than 2 seconds.
The red led flashes once every 2 seconds.
To deactivate the ring tone cancellation option, press the
3 times consecutively once again, in less than 2 seconds.
The led will return to its previous status.
«Automatic Release» Mode
When «Automatic Release» Mode is activated, the monitor will
automatically be activated 5 seconds after receiving a call from the
panel.
To activate the «Automatic Release» Mode, press and hold the
+ buttons simultaneously for 2 seconds.
The led remains green.
To deactivate the «Automatic Release» Mode, press and hold the
+ buttons simultaneously for 2 seconds.
The led will return to its previous status.
Note: If the «Cancel Ring Tone» and «Automatic Release» Mode
are activated at the same time, the monitor led will alternate
between red and green every second.
Audio Volume Settings
While communicating with the entry panel, press and hold the
button, until the menu appears on the screen.
- press the
sn3
- press the
(There are 5 possible audio options: sn1..sn5)
You can communicate with the entry panel without having received a
call by selecting «Auto-Start» (pressing
button.
button to increase the audio volume.
button to reduce the audio volume.
) and then pressing the
button 3 times
button
Page 27