Start-Up And Operation - S&P SAHARA 603 Manual De Instrucciones

.- The radiator has to be always transported using the
handles (Fig.1A)
.- Only for internal use
ASSEMBLY
For transport reasons, the support feet are not fitted and are supplied
separately within the packaging.
1.- Remove the support feet from the packaging.
2.- Mount the feed as it indicated in Fig.2. These are entered by pressure and
it does not require any tools for assembly.
3.- Check that the support feet have been mounted correctly.
4.- Put the radiator in vertical position and wait about 15 minutes before
connecting the device in the electrical ductwork, to ensure that all the oil inside
has drained into the base.

START-UP AND OPERATION

1.- Before connecting the device to the mains, check that the grid voltage
coincides with that shown on the data plate.
2.- Radiator description (Figure 1)
A – Handles for transport
B – Led "I" switch (ON) / 0 (OFF)
C – Thermostat command
D – Support Feet
E – Heating elements
3.- Turn the thermostat control (Fig. 1C) clockwise to its maximum position.
4.- Put the switch in "I" position (ON) (Fig.1B). Button is illuminated if properly
connected.
5.- When reaches the required temperature, rotate the thermostat control
(Fig.1C) anti clockwise until it clicks and turns off the device.
10
9