Start-Up And Operation - S&P SAHARA 1002 Instrucciones De Uso

- Do not handle the appliance with wet hands.
- Always use the radiator in an upright position.
- Do not cover or obstruct the air inlet grilles on the sides of the
appliance.
- If the radiator is covered, there is a risk of overheating.
- If the power cable is damaged, it must be replaced with a cable sup-
plied by S&P or the after sales service.
- When disposing of the appliance always adhere to the correspon-
ding provisions for the elimination of the internal oil.
ASSEMBLY
For transport reasons, the wheels are not fitted and are supplied
separately within the packaging.
1.- Remove the wheel set from the packaging.
2.- Turn the radiator over with care and rest it on a rug or other soft
surface to prevent damage.
3.- Insert the fixing ring in the hole on the base of the wheel set (Fig.1).
4.- Position the base of the wheel set underneath the radiator, which can
be lifted using the handle. Once correctly in place, position the ring in the
other hole in the base.
5.- Fix the ring onto the wheel set base using the wing nut (Fig.2).
6.- Check that the wheels are correctly fitted.

START-UP AND OPERATION

1.- Before connecting the device to the mains, check that the grid voltage
coincides with that shown on the data plate.
2.- The red pilot light indicates that the radiator is correctly connected to
the mains. This does not mean that the radiator is heating.
3.- Select the required power using the rotating switch (Fig.3).
8