Corghi ERCO 500 Manual De Uso página 70

8 CHAPTER 8 - OPERATION AND USE
8.1 CONTROLS
Controls for operating the lift are:
(1)
MAIN SWITCH
The function control can be set in five positions:
 0 position: lift electric circuit is not powered; the switch can be padlocked to prevent the use of the lift.
 1 position: lift electric circuit is powered
(2)
LIFTING BUTTON
 When pressed, motor and hydraulic circuit solenoid valve are operated and the lift will be raised
(3)
LOWERING BUTTON
 When pressed, the release hydraulic circuit solenoid valve, the lift will lower with warning signal.
PLUG HOLE (5)
( 4 )
PILOT LAMP
 it shows the electric circuit is powered
Figura 17a – CONTROLS
5
1
5
1
Lift operation can be summarized into four steps:
8.2 VEHICLE POSITIONING
 Place the vehicle at the centre of the platform and adjust the telescopic extensions.
 Place pads under the positions indicated by the motor vehicle's manufacturer for lifting.
8.3 LIFTING
 Set the main switch (1) to 1 position and press UP button to lift the vehicle to the required
level.
70
4
1
Be sure the safety area is free from people and objects during the final
travel
1
2
1
3
1