Tabla de contenido
Publicidad
Mounting
The appliance's electrical installation is made via rear channelling (see fig. 5).
• The terminal block for the power supply cable wires and their entrance hole
(Ø 22 mm - Ø 0.87" -) are located on the left-hand side of the dryer.
• This dryer is a class I appliance and includes an earth connection.
The installation process can be summed up as follows:
1. Drill four Ø 8 mm (Ø 0.31") holes using the supplied template. Clean up the holes
once they have been made. Insert the fourplugs until they are flush with the
surface (see figure 6).
2. Pass the electric cable from the wall through the entrance hole (Ø 22 mm - Ø
0.87" ).
3. Screw in the four supplied screws to firmly secure the base of the dryer to the
wall (see figure 7).
4. Connect the Neutral and Line (N, L) wires to the terminal block and the A/V cable
to the earth connection screw (Class I) (see figure 8).
5.- Installing the cover on the dryer:
- Position the cover frontally.
- Insert the upper tab in its housing in the base (see figure 9) by slightly tilting
the cover.
- Unscrew the screws in a counter-clockwise (CCW) direction using the supplied
special tool (see figure 10).
-11-
www.mediclinics.com
Publicidad
Tabla de contenido
