Makita AR410HR Manual De Instrucciones página 7

ENGLISH (Original instructions)
1. Safety glasses
2. Face shield
3. Deep
4. Shallow
5. Sunk too deeply (turn to raising
side)
6. Appropriate
7. Raised too high (turn to sink side)
8. Hook
9. Screw
10. Knob
11. Lever
12. Magazine cap
13. Screw channel
SPECIFICATIONS
Screw length
Screw capacity
Safety Device
Drive Adjustment
Screw Feed Mechanism
Min. hose diameter
Pneumatic tool oil
Dimensions (L X H X W)
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
......... Read instruction manual.
......... Wear safety glasses.
..................... Do not use on scaffoldings, ladders.
Intended use
The tool is intended for the preliminary interior work such
as fixing floor joists or common rafters and framing work in
2" x 4" housing.
PNEUMATIC NAILER/STAPLER
SAFETY WARNINGS
WARNING: Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in serious injury, electric shock
and/or fire.
Explanation of general view
14. Lead screw
15. Feeding claw
16. Hammer
17. Bar
18. Screwdriver
19. Hex bolt
20. Hex wrench
21. Top cap
22. Top cap gasket
23. Top cap spacer
24. Piston assembly
25. Driver guide
26. Eyeleteer
27. Rubber ring (white)
Model
Air pressure
Net weight
Dial Type (Adjustment Range: 6 mm)
Save all warnings and instructions for
END106-3
future reference.
For personal safety and proper operation and
maintenance of the tool, read this instruction manual
before using the tool.
General safety
• Do not permit those uninstructed to use the tool.
• No horseplay. Respect the tool as a working
implement.
• Do not operate when under the influence of alcohol,
drugs or the like.
ENE059-1
• Never alter the tool.
Personal protective equipments
• Always wear safety glasses to protect your eyes from
dust or fastener injury.
WARNING: It is an employer's responsibility to
enforce the use of safety eye protection equipment by
ENB067-4
the tool operators and by other persons in the
immediate working area.
For Australia and New Zealand only
Always wear safety glasses and face shield to protect
your eyes from dust or fastener injury. The safety
28. Cutter knife
29. Pin
30. Piston cap
31. Driver bit
32. Piston
33. New driver bit
34. Hollowed side
35. Holes
36. Rubber ring
37. Drain cock
38. Thinner
39. Stove
AR410HR
1.76 - 2.26 MPa (17.6 - 22.6 bar)
Coil type 25 - 41 mm
Sheet-collated 100 pcs
Contact Arm System
Feed Piston System
5.0 mm
ISO VG32 or equivalent
296 mm X 116 mm X 305 mm
2.0 kg
7