Functional Description - Makita AR410HR Manual De Instrucciones

be thrown and hit someone, or the tool itself can react
dangerously. Place the fasteners with care.
• Do not leave the loaded tool or the air compressor
under pressure for a long time out in the sun. Be sure
that dust, sand, chips and foreign matter will not enter
the tool in the place where you leave it setting.
• Never attempt to drive fasteners from both the inside
and outside at the same time. Fasteners may rip
through and/or fly off, presenting a grave danger.
Service
• Perform cleaning and maintenance right after finishing
the job. Keep the tool in tip-top condition. Lubricate
moving parts to prevent rusting and minimize friction-
related wear. Wipe off all dust from the parts.
• Ask Makita authorized service center for periodical
inspection of the tool.
• To maintain product SAFETY and RELIABILITY,
maintenance and repairs should be performed by
Makita Authorized Service Centers, always using
Makita replacement parts.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to safety
rules for the subject product. MISUSE or failure to
follow the safety rules stated in this instruction
manual may cause serious personal injury.
INSTALLATION
Selecting air hose (Fig. 2)
Use a high pressure resistant air hose.
Use an air hose as large and as short as possible to
assure continuous, efficient screw-driving operation.
CAUTION:
• Low air output of the compressor, or a long or smaller
diameter air hose in relation to the screw-driving
frequency may cause a decrease in the driving
capability of the tool.
Lubrication
Before and after use, oil the tool with pneumatic tool oil by
placing two or three drops into the air fitting. For proper
lubrication, the tool must be fired a couple of times after
pneumatic tool oil is introduced. (Fig. 3)
Steel sheet backing
009793
Steel sheet thickness
0.8 mm
Steel sheet thickness
0.6 mm
Steel sheet thickness
0.6 mm
Wood backing
Screw length

FUNCTIONAL DESCRIPTION

CAUTION:
• When adjusting driving depth, always lock the trigger
and disconnect the air hose.
Adjuster (drive depth adjuster) Operating
Method (Fig. 4 & 5)
CAUTION:
• When adjusting driving depth, always lock the trigger
and disconnect the air hose.
This driver is equipped with an adjuster for adjusting
screw driving depth.
Turn the adjuster to adjust driving depth. Driving
adjustment range is 6 mm. (one turn of adjuster adjusts
depth by approximately 0.8 mm.)
Hook (Fig. 6)
CAUTION:
• When using the hook, or changing its position, always
lock the trigger, and disconnect the air hose.Do not
fasten hook onto waist belt, etc.
• If hook becomes unfastened and the driver drops,
driver may operate by mistake, and lead to injury.
The hook is useful for hanging up the driver temporarily.
The mounting position of the hook on the driver can be
changed.
Remove the hook mounting screw, change position of
hook, and re-secure screw.
Switcher Mode Selection (Fig. 7)
This driver is equipped with a switcher to enable selection
of mode for optimum driving according to the material of
the workpiece. Set to mode positions shown in "Switching
Mode Chart" below for optimum use. Thoroughly turn the
knob until it clicks to a halt properly at either position (1) or
(2). If the driver is used with the switcher in a position
between (1) and (2), driver components may become
damaged, and/or normal performance not achieved.
(2) (2)
(1) (1)
(1) (1)
(1) (1)
25 mm 28 mm
(2)
(1).(2)
(1)
(1) (1)
32 mm 41 mm
9