Getting Started; Connections - ARP ODYSSEY Manual De Usuario

ARP ODYSSEY

Getting started

Connections

The following illustration shows an example of typical connections. Connect your
equipment as appropriate for your needs.
to electrical
outlet
AC adaptor (included)
MIDI cable
MIDI OUT
USB cable
Computer
Mono phone
cable
Volume
pedal
Mono phone
cable
To an external
audio source, etc.
XLR cable
Pedal switch
Mono phone
cable
Monitor amplifier, etc.
Other example connections
You can use patch cables to connect the ODYSSEY to a sequencer as shown below, so
that the sequencer can control the ODYSSEY to produce sound.
If you're connecting the ODYSSEY with the SQ‐1, connect the ODYSSEY's PEDAL
jack to the SQ‐1's CV OUT jack so that the ODYSSEY's VCO 2 pitch and filter can be
controlled.
CV OUT
********
Headphones
You must turn off the power of all devices before connecting anything. If you
connect devices while the power is on, you might damage your speaker system
or cause your equipment to malfunction or be damaged.
If you want to connect a pedal, use a monaural cable to connect the PEDAL jack
of the ODYSSEY to the OUT 1 or OUT 2 jack of an optional (separately sold)
Korg VP‐10 volume pedal. In this case, the MINIMUM VOLUME of the VP‐10
must be set to 0 (minimized).
If you want to use a pedal switch to turn portamento on/off, connect an optional
Tip:
(separately sold) Korg PS‐1 or PS‐3 pedal switch to the PORTAMENTO
FOOTSWITCH jack of the ODYSSEY. Portamento turns off when you press the
pedal switch; releasing the pedal switch applies the portamento effect at the time
specified by the PORTAMENTO slider.
- 14 -
Sequencer etc.
CV OUT
GATE OUT
ODYSSEY mini
CV IN
GATE IN