Front Panel (Vco-2 Section) - ARP ODYSSEY Manual De Usuario

ARP ODYSSEY

Front panel (VCO-2 section)

c
a
b
d
e
f
g
h i j
- 8 -
The following settings are for oscillator 2 (VCO‐2).
a . FREQUENCY COARSE slider (green) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .[20(0 .2)Hz...2K(20)Hz]
Rough pitch adjustment. This is adjustable in the range of 20 Hz – 2 kHz.
If the SYNC switch is on, this changes the overtone structure rather than the
pitch.
The frequency range (20 Hz – 2 kHz) is an approximate value.
b . FREQUENCY FINE slider (green) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [±400cent]
Fine pitch adjustment.
If the SYNC switch is on, this changes the overtone structure rather than the
pitch.
c . SYNC switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . OFF, ON
Turns sync on/off.
If this is off, duophonic performance is possible. If this is on, VCO‐2 is
synchronized with the frequency (pitch) of VCO‐1.
d . FM depth slider (pink)
e . FM depth slider (yellow)
Adjusts the depth of FM (Frequency Modulation) when it is is applied.
f . PULSE WIDTH (WIDTH) slider (blue) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [50%...MIN]
Adjusts the pulse width.
g . PULSE WIDTH (MOD) slider (pink)
Adjusts the depth of pulse width modulation.
h . FM source switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .[LFO
Selects either modulation by an LFO sine wave or modulation by the S/H MIXER
(sample and hold mixer) or pedal signal.
If you select S/H MIXER OR PEDAL, the modulation can be controlled by an
optional (separately sold) volume pedal connected to the pedal jack.
i . FM source switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [S/H, ADSR
Selects either Sample and Hold or the envelope generator (ADSR) as the
modulation source.
j . Pulse width modulation souece switch . . . . . . . . . . . . . . . . . . .[LFO
Selects the source that will apply pulse width modulation.
, S/H MIXER OR PEDAL]
]
, ADSR ]