Reliable Velocity V50 Manual De Instrucciones página 10

OPERATION
Plug the iron into the main outlet. The operation/temperature LED (5) will light
iron by the handle and pass the sole over the garment to be ironed.
TEMPERATURE SELECTION
The V50 has 4 temperature settings, which can be selected by pressing the
temperature selector (3).
Press the temperature selector (3) as many times as required until the desired
The operation/temperature LED (5) will blink until the selected temperature
level has been reached. Once the temperature has been reached the LED will
stop blinking.
STEAM SELECTION
Once the operation/temperature LED (5) stops blinking indicating that the selected
temperature has been reached:
handle (fig.3).
been reached.
people. One merely has to press one of the two silicone buttons.
steam will now stop until one of the two buttons is pressed again.
AUTOMATIC SHUT OFF
The Velocity V50 has an automatic shut-off system. It is shut-off automatically
eight minutes after the last time it was used. This means that once the shut-
off device is activated, it ceases to heat and begins to cool down. To wake it up
again, press the temperature button (3) for at least one second.
The auto-shut off mode can be manually selected by pressing the temperature
button for three seconds, and wake it up again by pushing the same button for
more than one second.
06