Important - EYENIMAL Training Pulse Manual De Instrucciones

 Coding of the remote control and receiver collar
Each remote control has its own individual radio operator code. The coding of the remote control with the
receiver collar enables the two units to work together.
IMPORTANT: before beginning the coding (first use of the collar or re-coding), make sure no other
person is using his EYENIMAL Training Pulse or other products from the NUM'AXES range close by:
your receiver collar could accidentally record the code of his remote control. If that occurs, re-code the
remote control with the receiver collar.
CODING PROCEDURE FOR THE 1ST USE
1 To begin the coding procedure, the remote control must be ready for use (battery in its housing).
2 Activate the collar: move the remote control towards the collar so that the round mark on the remote
control
comes into contact with the white mark on the collar, hold for 1 second.
3 Move the remote control away from the receiver collar.
4 Press the button of the remote control. A beep sound is emitted; the collar is then synchronized with
your remote control.
 Reprogram a receiver collar
The receiver collar can be re-coded indefinitely, either with the same remote control, or with a new one
(Ref. § Re-coding procedure).
Gb - 21
Diagram 4
Activate/Deactivate
a receiver collar
with a remote control
Place these 2 areas
together during 1 second