First Use From New - EYENIMAL Training Pulse Manual De Instrucciones

First use from new


 Fitting the battery receiver collar
- Unscrew the 4 screws of the top of using a screwdriver.
- Insert the battery (3-V Lithium CR2) paying attention to follow polarity indicated on the battery housing
- A beep sound (low pitch) is emitted, indicating the correct installation of the battery.
If you do not hear any beep after having inserted the battery,
remove it immediately from its housing. Check the polarity before trying again.
- Before putting the lid back in place, check that the rubber seal is in its groove.
- Screw up the 4 screws with care (do not overtighten them).
 Activate/deactivate the remote control
Remote control is supplied with battery fitted.
- Activate: as soon as the battery is in place, the remote control is ready for use.
- Deactivate: to deactivate the remote control you have to remove the battery from its housing.
To increase the battery life of the remote control, we recommend you to deactivate the unit if you are not
using it for a long period.
 Activate/deactivate the receiver collar
A magnet located in the remote control is used to switch the receiver collar On or Off.
- Activate: move the remote control towards the collar so that the round mark on the remote control
comes into contact with the white mark on the receiver collar, hold for 1 second. The indicator light on
the collar will flash in green indicating that the receiver is On.
- Deactivate: move the remote control towards the collar so that the round mark on the remote control
comes into contact with the white mark on the collar, hold for 1 second. The indicator light on the collar
will flash from green to red and then off: the receiver is Off.
To increase the battery life of the receiver collar, we recommend you to deactivate the unit if you are
not using it for a long period.
Gb - 20
Fig. 3