Installation And Starting - Cattani Turbo-Smart A Manual De Instrucciones

Installation and starting

HANDLE
WITH CARE
WARNING
WARNING
Recommended precautions
SHOCKWATCH R
Before unpacking the appliance, check the warning shockwatch
RED INDICATES ROUGH HANDLING
on the carton.
IF RED, NOTE ON BILL OF LADING
INSPECTION MAY BE WARRANTED
In case of it being red or the carton being damaged, accept the
material reserving the right to examine the machine.
MODEL L-55 (37g)
Unpack the appliance following the instructions shown on the
package. The carton is recyclable. Dispose of it in compliance
with regulations in force.
The machine installation must be carried out by a specialist
equipped with the necessary tools.
Install the appliance in a clean location, far from heat sources,
humidity and dust.
Turbo-Smart can be installed outdoors (on a balcony, in veranda
or gardens), provided that it is sheltered from rain, splashing,
humidity, frost and direct sunshine.
In the plant room temperature can range from a minimum of
+ 5 °C to +35 °C max.
Turbo-Smart fi tted with box, for indoors our outdoors installation,
can be supplied with antifreeze device.
In case the plant room must be ventilated or air-conditioned,
we suggest to contact a thermo-technician for a personalized
project. The plant room must be closed to patients and extra-
neous people. If such a room is not available, machines must
be protected by a suitable cover, which must not be easy to
remove.
Use protections and danger warning boards to prevent acci-
dental risk from electrical shocks or the possibility (unlikely
but not excludible) of fi re, explosion and contaminating air or
liquid leakage.
Use indoors and outdoors boxes designed and produced by
the manufacturer of the machines only.
Keep the plant room free from fl ammable material. Make sure
that there is no possibility for gas leakages.
Do not connect damaged appliances to the mains. Do not use
extension leads, multiple plugs or sockets. Before connecting
the machine to the mains, ascertain that the feeding line is
complying with the regulations C.E.I. 64-8 and that a thermal
switch and a residual current operated circuit-breaker (class
A or B) (16A) according to the regulations EN 61008-1 are
present.
Light coloured, wooden, linoleum, rubber or marble fl oors can
change colour or get marked if they are kept in contact with
rubber vibration-proof devices (1). Therefore, it is necessary to
1
use a rubber sheet or some other suitable material to isolate
vibration-proof devices from the fl oor.
22
INDEX
HOME