Hoshizaki FM-170EE-HC Manual De Instrucciones página 5

ENGLISH
3) Wash the bin liner, plastic spill flap and drain
cap with a neutral non-abrasive cleaner. Rinse
thoroughly.
Note: Take care not to damage the bin control
actuator at the top of the bin.
4) Mix 5 litres of water with 18 ml of 5.25% sodium
hypochlorite solution in a suitable container.
5) Soak a clean sponge or cloth with the solution and
wipe all the surfaces of the bin liner, plastic spill
flap and drain cap.
6) Refit the drain cap. Wipe the inside surface of the
bin door with the solution. Close the bin door.
7) The remaining solution can be used to sanitise
utensils.
Note: Do not wipe dry or rinse after sanitising, but
allow to air dry.
[3] Storage Bin Door
Clean the storage bin door at least once a week, using
a neutral non-abrasive cleaner. Rinse thoroughly
after cleaning and sanitise as required.
[4] Air Filter
Plastic mesh air filters remove dirt or dust from the
air, and keep the condenser from getting clogged. If
the filters get clogged, the icemaker's performance
will be reduced.
Contact an authorised Hoshizaki service company
to complete air filter cleaning as part of a regular
maintenance programme.
2. INSPECTION AND MAINTENANCE
IMPORTANT
To achieve optimum icemaker performance, the
following parts need periodic inspection and
maintenance:
Extruding head (upper bearing)
Housing (lower bearing)
Mechanical seal
These parts should be inspected after two
years from installation or 10,000 hours of
operation, whichever comes first, and once
a year thereafter. Replacement of these
parts is required if wear exceeds factory
recommendations.
Their service life, however, depends on water
qual i ty and envi ronment. More frequent
inspection and maintenance are recommended
in bad or severe water conditions.
Consult with your local Hoshizaki service agent
about inspection and maintenance service.
3. BEFORE CALLING A SERVICE AGENT
WARNING
Do not damage the refrigerant circuit. In the
case of accidental damage to the refrigeration
system causing refrigerant leak, do not create
a source of ignition in the area. Do not operate
electrical switches or plugs in the area, do not
use naked flame. Immediately ventilate the
area by opening doors and/or windows, and call
service engineer.
If the icemaker does not work properly or does not
work at all, before calling for service, check that:
* The power is supplied to the unit.
* The water is turned on.
For further assistance or advice, contact your local
Hoshizaki service agent.
4. WARRANTY
Hoshizaki provides warranty in accordance with
the legislation of the customer's own country of
residence, for two years starting from the date on
which the appliance is sold to the end user.
The warranty only covers defects in material or
workmanship.
The repairs under warranty may only be carried
out by Hoshizaki's authorised service centre. When
making a claim under the warranty, the original bill of
purchase (with purchase date) must be submitted.
The warranty will not apply in cases of:
* Normal wear and tear
* Incorrect use, e.g. overloading of the appliance,
use of non-approved accessories
* U s e o f f o r c e , d a m a g e c a u s e d b y e x t e r n a l
influences
* Damage caused by non-observance or the user
manual, e.g. connection to an unsuitable mains
supply or non-compliance with the installation
instructions
4