Material Preparation - WAGNER CONTROL SPREY HVLP Manual Del Propietário

Assembly
1. Align the arrow on the spray gun with the "unlock" symbol
on the spray gun handle.
2. Insert and twist the spray gun into the turbine toward the
"lock" symbol on the spray gun handle. The tab below the
trigger will lock the two pieces into place.
3. Insert the air hose tightly into the connections onto the
spray gun (a) and the turbine (b). The connections can be
positioned as desired.
(a)
Aligning the Suction Tube
If you are going to be
spraying in a
downward direction,
the angled end of the
suction tube should be
pointing toward the
front of the gun.
If you are going to be
spraying in an upward
direction, the angled
end of the suction tube
should be pointing
toward the rear of the
gun.
By pointing the suction tube in the proper direction, you
will not have to refill the container as often.
English
Setup

Material Preparation

Before spraying, the material being used may need to be
thinned with the proper solvent as specified by the
material manufacturer. Never exceed the thinning
advice given by the coating manufacturer.
Do not use materials with a flashpoint below 70°F
(21°C). Follow the instructions below.
1. Stir the spraying material thoroughly before measuring
viscosity.
2. Dip the viscosity test cup completely into the spraying
material.
3. Hold the test cup up and measure the time in seconds until
the liquid empties out. This time is referred to below as
Runout Time.
Material
1) Oil enamel
(b)
2) Oil based primer
3) Oil stain
4) Clear sealer
5) Polyurethane
6) Varnish
7) Lacquer sanding sealer
8) Lacquer
9) Automotive finishes
Material to be sprayed should always be strained to
remove any impurities in the paint which may enter and
clog the system. Impurities in the paint will give poor
performance and a poor finish.
Fill Container
1. Unscrew the cup from the spray gun.
2. After the material has been properly thinned and strained,
fill the container to the top of the neck.
3. Carefully screw the cup back onto the spray gun.
4
Thinning Chart
MATERIAL FLASH POINT MUST BE 70°F (21°C) OR
HIGHER.
Runout Time
25-40
30-45
No thinning required
No thinning required
No thinning required
20-50
25-35
25-35
20-40