Cleaning The Spray Gun - WAGNER CONTROL SPREY HVLP Manual Del Propietário

Cleaning the Spray Gun

Special cleanup instructions for use with
flammable solvents (must have a flashpoint above
70ºF (21ºC):
• Always flush spray gun outside.
• Area must be free of flammable vapors.
• Cleaning area must be well-ventilated.
• Do not submerge turbine!
1. Turn the turbine OFF.
2. Trigger the spray gun so that
the material inside the spray
gun flows back into the
container.
3. Unscrew the container.
Empty any remaining material
back into the material
container.
4. Pour a small amount of the
appropriate cleaning solution
into the cup (warm, soapy
water for latex materials;
mineral spirits for oil-based
materials). Clean cup and
suction tube and properly
dispose of cleaning
solution.
5. Refill the cup with NEW
cleaning solution.
6. Attach the cup to the gun and
turn on the turbine.
English
Cleanup
7. Spray the solution through the
gun for two seconds in a safe
area. Spray again for two
seconds. Turn off the turbine,
and trigger the spray gun so
that the material inside the
spray gun flows back into the
container.
8. Wipe the exterior of the cup
and gun until clean.
9. Unscrew the nut and
remove the air cap
and nozzle.
10. Clean the container,
suction tube, air cap
and nozzle with a
cleaning brush and
the appropriate
cleaning solution.
Never clean nozzle or air holes in the spray gun with
sharp metal objects. Do not use solvents or lubricants
containing silicone.
11. Push the tab below
the trigger, twist and
separate the spray
gun from the handle.
12. Clean the rear of the
spray gun (a) with the
appropriate cleaning
solution. Use a thin
layer of petroleum
jelly to lubricate the
O-ring (b).
Reassemble spray
gun.
6
(a)
(b)