On / Off Switch - WAGNER CONTROL SPREY HVLP Manual Del Propietário

ON / OFF Switch

The ON/OFF switch is located underneath the end of the
carrying handle on the turbine as shown below.
Adjust Spray Pattern
The spray pattern shape is adjusted by turning the ears
of the air cap to either the vertical, horizontal, or
diagonal positions. The positions of the air cap and the
corresponding spray pattern shapes are illustrated
below.
Test each pattern and use whichever pattern is suitable
for your application.
Round pattern
Horizontal pattern
Vertical pattern
NEVER trigger the gun while adjusting the ears on
the air cap. NEVER point the spray gun at any part
of the body.
Material Flow Adjustment
Set the material volume by turning the regulator on the
trigger of the spray gun.
Spraying
Proper Spraying Technique
If spraying with an HVLP spray system is new or
unfamiliar to you, it is advisable to practice on a piece of
scrap wood or cardboard before beginning on your
intended workpiece.
Surface Preparation
All objects to be sprayed should be thoroughly cleaned before
spraying material on them. Areas not to be sprayed may, in
certain cases, need to be masked or covered.
Spray Area Preparation
The spray area must be clean and free of dust in order to avoid
blowing dust onto your freshly sprayed surface.
How to Spray Properly
Nut
Air cap
When you quit spraying for any length of time, turn the
turbine OFF and place the spray gun into the spray gun
holder on the turbine.
5
• Position the spray gun perpendicular to and one (1) or more
inches from the spray surface, depending upon the spray
pattern size desired.
• Spray parallel to the surface with smooth passes at a
consistent speed as illustrated below. Doing this will help
avoid irregularities in the finish (i. e. runs and sags).
• Always apply a thin coat of material on the first pass and
allow to dry before applying a second, slightly heavier coat.
Even coat throughout
Keep stroke smooth and at an even speed
• When spraying, always trigger the spray gun after spray
pass has begun and release trigger before stopping the
pass. Always keep the gun pointed squarely at the spray
surface and overlap passes slightly to obtain the most
consistent and professional finish possible.
Light coat Heavy coat
Do not flex wrist while spraying.
1 to 12 inches
Correct
Light coat
Incorrect
English