Taurus ITALICA INDUCTION Manual De Instrucciones página 8

English
Aluminium coffee maker
Italica Induction
Dear customer,
Many thanks for choosing to purchase a TAURUS
brand product.
Thanks to its technology, design and operation
and the fact that it exceeds the strictest quality
standards, a fully satisfactory use and long pro-
duct life can be assured.
DESCRIPTION
A Lower body.
B Funnel Filter.
C Upper body.
D Safety valve.
SAFETY ADVICE AND WAR-
NINGS
- Read these instructions care-
fully before switching on the
appliance and keep them for fu-
ture reference. Failure to follow
and observe these instructions
may result in an accident.
- -Do not permit chidren to go
near the coffee maker when it is
in use
- Do not operate the opening
/ closing system before the
coffee maker cools and after
emoving it from the heat source
- Ensure that the coffee maker is
properly closed before using it
- This appliance is for domestic
use only, not for industrial use.
- Do not leave the appliance
within the reach of children or
disabled people.
- No responsibility is accepted for
damage caused by improper
handling, or by use other than
that designated in this manual.
- Periodically check the condition
of the accessories (rubber seal,
filter, etc.) and replace them
when they show signs of dete-
rioration.
- Do not use the coffee maker
without water in the distiller.
- Do not use this appliance for
purposes other than those de-
signated.
- Do not touch the hot surfaces.
Use the handle and the puller.
- Use only the replacement parts
supplied by the manufacturer
and its authorised support ser-
vices
- Ensure that the jet of steam
which can exit through the safe-
ty valve is not directed near the
user.
INSTRUCTIONS FOR USE
- Before using it, clean the internal part of the
coffee maker well with water and detergent.
- Unscrew the upper body (C) from the lower
body (A).
- Fill the lower body (A) with water to the valve
(D).
- Put the ground coffe into the funnle (B) and
place it in its housing.
- Firmly screw the two bodies together.
- Place the coffee maker on a heat source (gas,
vitroceramic or electric).
- Remove the coffee maker from theheat source
when the coffee has exited completely.